Difference between revisions of "Mindmotion-MB-036"
(Created page with "__TOC__ This article describes specifics for the Mindmotion PLUS5270 MM32F5270 evaluation board. 450px == Minimum requirements == *...") |
|||
Line 1: | Line 1: | ||
__TOC__ |
__TOC__ |
||
− | This article describes specifics for the Mindmotion |
+ | This article describes specifics for the Mindmotion MB-036 evaluation board. |
− | [[File: |
+ | [[File:MM-MB-036-board.jpg|450px]] |
== Minimum requirements == |
== Minimum requirements == |
||
− | * J-Link software V7. |
+ | * J-Link software V7.82d or later |
== Preparing for J-Link == |
== Preparing for J-Link == |
||
Line 19: | Line 19: | ||
It is a simple Hello World sample linked into the internal flash.<br> |
It is a simple Hello World sample linked into the internal flash.<br> |
||
====SETUP==== |
====SETUP==== |
||
− | *J-Link software: V7. |
+ | *J-Link software: V7.82d |
*Embedded Studio: V6.34 |
*Embedded Studio: V6.34 |
||
− | *Hardware: Mindmotion |
+ | *Hardware: Mindmotion MB-036 |
*Link: [[File:MM_PLUS5270_MM32F5270_TestProject_ES_V634.zip]] |
*Link: [[File:MM_PLUS5270_MM32F5270_TestProject_ES_V634.zip]] |
Revision as of 12:25, 28 November 2022
This article describes specifics for the Mindmotion MB-036 evaluation board.
Minimum requirements
- J-Link software V7.82d or later
Preparing for J-Link
- Connect the J-Link to the SWD header (P15)
- Power the board via external power supply / power jack (J4)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Mindmotion PLUS5270 MM32F5270.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.82d
- Embedded Studio: V6.34
- Hardware: Mindmotion MB-036
- Link: File:MM PLUS5270 MM32F5270 TestProject ES V634.zip