Difference between revisions of "Microchip CuriosityPro PIC32CMJH01"
(→Preparing for J-Link) |
(→Preparing for J-Link) |
||
Line 6: | Line 6: | ||
== Preparing for J-Link == |
== Preparing for J-Link == |
||
*Connect the J-Link to CORTEX DEBUg. |
*Connect the J-Link to CORTEX DEBUg. |
||
− | *Power the board via |
+ | *Power the board via DEBUG USB. |
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
||
[[File:Microchip_PIC32CMJH01_PIC32CM5164JH01_connect.png|400px]] |
[[File:Microchip_PIC32CMJH01_PIC32CM5164JH01_connect.png|400px]] |
Revision as of 11:33, 14 September 2023
This article describes specifics for the Microchip Curiosity Pro PIC32CMJH01 evaluation board.
Preparing for J-Link
- Connect the J-Link to CORTEX DEBUg.
- Power the board via DEBUG USB.
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Microchip Curiosity Pro PIC32CMJH01 .
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.92f
- Embedded Studio: V7.20
- Hardware: Microchip Curiosity Pro PIC32CMJH01
- Link: File:Microchip PIC32CMJH01 PIC32CM5164JH01 TestProject ES 7V20.zip