Difference between revisions of "NXP FRDM-KE17Z512"
(Created page with "__TOC__ This article describes specifics for the NXP FRDM-KE17Z512 evaluation board.<br> '''[PICTURE OF BOARD]''' 450px == Preparing for...") |
|||
| Line 2: | Line 2: | ||
This article describes specifics for the NXP FRDM-KE17Z512 evaluation board.<br> |
This article describes specifics for the NXP FRDM-KE17Z512 evaluation board.<br> |
||
| − | '''[PICTURE OF BOARD]''' |
||
[[File:NXP_FRDM-KE17Z512_board.jpg|450px]] |
[[File:NXP_FRDM-KE17Z512_board.jpg|450px]] |
||
Revision as of 14:27, 6 November 2023
This article describes specifics for the NXP FRDM-KE17Z512 evaluation board.
Preparing for J-Link
- Connect the J-Link to ......
- Power the board via........
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
[PICTURE OF CONNECT] 400px
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the NXP FRDM-KE17Z512.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.xx
- Embedded Studio: V7.20
- Hardware: NXP FRDM-KE17Z512
- Link: File:NXP FRDM-KE17Z512 TestProject ES V452b.zip
