Difference between revisions of "NXP FRDM-MCXN947"

From SEGGER Wiki
Jump to: navigation, search
(→‎Preparing for J-Link)
Line 5: Line 5:
   
 
== Preparing for J-Link ==
  
== Preparing for J-Link ==
−
*Connect the J-Link to J11, J6 hast to set in order to disable MCU-Link on the PCB and work with J-Link.
 +
*Connect the J-Link to J23, J22 hast to set in order to disable MCU-Link on the PCB and work with J-Link.
−
*Power the board via J5,J27,J28 (depending on setting of J26)
 +
*Power the board via USB J11.
 
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows:
  
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows:
 
[[File:NXP_FRDM-MCXN947_connect.png|400px]]
  
[[File:NXP_FRDM-MCXN947_connect.png|400px]]

Revision as of 16:13, 15 December 2023

This article describes specifics for the NXP FRDM-MCXN947 evaluation board.
NXP FRDM-MCXN947 board.jpg

Preparing for J-Link

  • Connect the J-Link to J23, J22 hast to set in order to disable MCU-Link on the PCB and work with J-Link.
  • Power the board via USB J11.
  • Verify the Connection with e.g. J-Link Commander. The output should look as follows:

NXP FRDM-MCXN947 connect.png

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the NXP FRDM-MCXN947.
It is a simple Hello World sample linked into the internal flash.

SETUP

Retrieved from "https://wiki.segger.com/index.php?title=NXP_FRDM-MCXN947&oldid=17304"