Difference between revisions of "NXP iMX6SX SABRE"
(Created page with "__TOC__ This article describes specifics for the NXP iMX6SX SABRE evaluation board.<br> 450px == Preparing for J-Link == *Connect the J-Link to...") |
(→SETUP) |
||
Line 16: | Line 16: | ||
*Embedded Studio: V7.20 |
*Embedded Studio: V7.20 |
||
*Hardware: NXP iMX6SX SABRE |
*Hardware: NXP iMX6SX SABRE |
||
− | *Link: |
+ | *Link: [[Media:IMX6_SABRE_ES_Example.zip|NXP_IMX6SX_SABRE_ES_Example.zip]] |
Revision as of 17:43, 23 February 2024
This article describes specifics for the NXP iMX6SX SABRE evaluation board.
Preparing for J-Link
- Connect the J-Link to JTAG connector (J17)
- Power the board via 5V power jack (J1)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the NXP iMX6SX SABRE.
The application is a simple count loop running from Flash directly.
SETUP
- J-Link software: V7.xx
- Embedded Studio: V7.20
- Hardware: NXP iMX6SX SABRE
- Link: NXP_IMX6SX_SABRE_ES_Example.zip