Difference between revisions of "XHSC EV-HC32F460"
m (Torben.scharping moved page HDSC EV-HC32F460 to XHSC EV-HC32F460) |
|
(No difference)
| |
Revision as of 10:41, 26 June 2024
This article describes specifics for the HDSC EV-HC32F460-LQFP100-050-V1.3 evaluation board.
Minimum requirements
- J-Link software V7.60b or later
Preparing for J-Link
- Connect the J-Link debug connector.
- Power the board via usb power supply
- The board should look like this:
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the HDSC EV-HC32F460-LQFP100-050-V1.3. It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.60b
- Embedded Studio: V5.60
- Hardware: HDSC EV-HC32F460-LQFP100-050-V1.3
- Link: File:HDSC HC32F460 TestProject ES V560.zip
