Difference between revisions of "TMPM46BF10FG Evaluation Board"
(Created page with "The Toshiba TMPM46BF10FG Evaluation Board (TMPM46BF10FG MCU on it) can not be used out-of-the-box with J-Link for two reasons: * The 19-pin cortex-m connector is not populated...") |
(No difference)
|
Revision as of 11:56, 21 January 2016
The Toshiba TMPM46BF10FG Evaluation Board (TMPM46BF10FG MCU on it) can not be used out-of-the-box with J-Link for two reasons:
- The 19-pin cortex-m connector is not populated
- The on-board debugger drives the debug interface signals
However, below is a small instruction of which steps needs to be done, to be able to use the board with J-Link.
- Populate the 19-pin Cortex-M connector (CN2)
- Close jumper bridge DAPBOOT (CN14) to make sure that the on-board debugger is halted in reset
Flash programming support including the Unlimited Breakpoints in flash feature has been added in V5.11b of the J-Link software and documentation package. So any version >= V5.11b comes with full debug / flash programming support.