Mindmotion-MB-032
Revision as of 12:12, 5 December 2022 by Torben.scharping (talk | contribs)
This article describes specifics for the Mindmotion MB-032 evaluation board.
Minimum requirements
- J-Link software V7.82d or later
Preparing for J-Link
- Connect the J-Link : VTref= CN6-9 / GND=CN6-7 / SWDIO=CN9-8(18 on PCB) / SWDCLK=CN6-4
- Power the board via USB (CN3)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Mindmotion MB-032 ##########################################.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.82d
- Embedded Studio: V6.34
- Hardware: Mindmotion MB-032
- Link: File:MM xxx TestProject ES V634.zip