Mindmotion-MB-036
Revision as of 16:25, 9 December 2022 by Torben.scharping (talk | contribs)
This article describes specifics for the Mindmotion MB-036 evaluation board.
Minimum requirements
- J-Link software V7.82e or later
Preparing for J-Link
- Connect the J-Link: VTref= CN9-32(64 on PCB) / GND=CN9-31(63 on PCB) / SWDIO=CN9-14(46 on PCB) / SWDCLK=CN9-17(49on PCB)
- Power the board via USB (CN2)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Mindmotion MB-036 MM32F3277G7P.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.82e
- Embedded Studio: V6.34
- Hardware: Mindmotion MB-036
- Link: File:MM xxx TestProject ES V634.zip