MindMotion Mini-F0163
Revision as of 15:11, 15 May 2024 by Simon Buchholz (talk | contribs)
This article describes specifics for the MindMotion Mini-F0163 evaluation board.
[PICTURE OF BOARD]
450px
Preparing for J-Link
- Connect the J-Link to CN5.
- Power the board via CN2 or CN3.
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the MindMotion Mini-F0163.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.86f
- Embedded Studio: V6.34
- Hardware: MindMotion Mini-F0163
- Link: File:MindMotion Mini-F0163 MM32F0163D7PV TestProject ES 6V34.zip