Xilinx Zynq UltraScalePlus
This article describes device specifics of the Xilinx Zynq UltraScale+ series devices.
Families
The Zynq UltraScale+ series consists of the following families:
- Zynq UltraScale+ CG (2x Cortex-A53, 2x Cortex-R5)
- Zynq UltraScale+ DR (4x Cortex-A53, 2x Cortex-R5)
- Zynq UltraScale+ EG (4x Cortex-A53, 2x Cortex-R5)
- Zynq UltraScale+ EV (4x Cortex-A53, 2x Cortex-R5)
Debugging
Debugging the Cortex-R5
Software requirements
J-Link software V6.45c or later is required. Older versions will not work.
In order to connect to and debug one of the available Cortex-R5 on the UltraScale+ series, an UltraScale+ device with XCZU..._R5_0 must be selected. For a list of supported device names, please refer to the list of supported devices on the SEGGER website.