MindMotion Mini-F0040
Revision as of 15:53, 24 March 2023 by Torben.scharping (talk | contribs)
This article describes specifics for the MindMotion Mini-F0040 evaluation board.
[PICTURE OF BOARD]
450px
Preparing for J-Link
- Connect the J-Link to CN2.
- Power the board via CN1.
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the [SiliconVendor] [EvalBoardName].
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V6.74
- Embedded Studio: V4.52b
- Hardware: [SiliconVendor] [EvalBoardName]
- Link: File:VENDOR DEVICENAME TestProject ES V452b.zip