TI LP-CC1311P3

From SEGGER Wiki
Revision as of 11:29, 13 June 2023 by Torben.scharping (talk | contribs) (→‎SETUP)
Jump to: navigation, search

This article describes specifics for the TI Launchpad CC1311P3 evaluation board.

TI LP-C1311P3 CC1311P3 board.jpg

Preparing for J-Link

  • Connect the J-Link to Target In
  • Power the board via USB
  • Verify the Connection with e.g. J-Link Commander. The output should look as follows:

[PICTURE OF CONNECT] VENDOR DEVICE CONNECT.PNG

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the [SiliconVendor] [EvalBoardName].
It is a simple Hello World sample linked into the internal flash.

SETUP

Retrieved from "https://wiki.segger.com/index.php?title=TI_LP-CC1311P3&oldid=15102"