TI LP-CC1311P3
This article describes specifics for the TI Launchpad CC1311P3 evaluation board.
Preparing for J-Link
- Connect the J-Link to Target In
- Power the board via USB
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the [SiliconVendor] [EvalBoardName].
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.88g
- Embedded Studio: V6.34
- Hardware: [SiliconVendor] [EvalBoardName]
- Link: File:TI LP-C1311P3 CC1311P3 TestProject ES V634.zip