NUCLEO-G431RB
Revision as of 15:20, 1 September 2023 by Simon Buchholz (talk | contribs) (Created page with "__TOC__ This article describes specifics for the ST NUCLEO-G431RB evaluation board.<br> 400px == Preparing for J-Link == *Power the board via...")
This article describes specifics for the ST NUCLEO-G431RB evaluation board.
400px
Preparing for J-Link
- Power the board via Micro USB (CN1)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
- Note select device: "STM32G431RB".
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the ST NUCLEO-G431RB.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.90
- Embedded Studio: V7.20
- Hardware: ST NUCLEO-G431RB
- Link: File:NUCLEO-G431RB Projekt.zip