Microchip CuriosityPro PIC32CMJH01
Revision as of 11:32, 14 September 2023 by Torben.scharping (talk | contribs) (Created page with "__TOC__ This article describes specifics for the Microchip Curiosity Pro PIC32CMJH01 evaluation board.<br> 450px ==...")
This article describes specifics for the Microchip Curiosity Pro PIC32CMJH01 evaluation board.
Preparing for J-Link
- Connect the J-Link to J400.
- Power the board via J200.
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Microchip Curiosity Pro PIC32CMJH01 .
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.92f
- Embedded Studio: V7.20
- Hardware: Microchip Curiosity Pro PIC32CMJH01
- Link: File:Microchip PIC32CMJH01 PIC32CM5164JH01 TestProject ES 7V20.zip