Infineon PMG1

The Infineon PMG1 is a family of high-voltage USB PD MCUs with Arm® Cortex®-M0/Cortex-M0+ CPU.

Flash Banks

Internal Flash

Subfamily	Flash Bank	Base address	Size	J-Link Support
PMG1-B1	Internal Flash	0x00000000	128 KB

Watchdog Handling

• The device has a watchdog WDT.
• The watchdog is not fed during flash programming.

Device Specific Handling

Connect

The connect sequence of PMG1 devices is very time critical and is performed from the J-Link's side directly in either one of these 2 modes:

• Reset mode:
  

J-Link toggles the XRES line and then sends SWD commands.
Reset mode is not supported by EZ-PD™ PMG1-S0 MCU devices because they do not have an XRES pin.

• Power Cycle mode:
  

J-Link powers on the target and then starts sending the SWD commands.
Therefore the target device needs to be supplied via Pin 19 of the J-Link and Pin 1 also needs to be connected to pin 19 of the J-Link.
Make sure to set VSupply (pin 19) correctly before connecting it to the target board. This is the only mode supported by EZ-PD™ PMG1-S0 MCU devices.

Reset

• The device uses custom reset via AIRCR.SYSRESETREQ and halt at application entry point.

Limitations

Attach

Attach is not supported because the J-Link resets the device on connect.

Evaluation Boards

• Infineon EVAL_PMG1_B1_DRP

Example Application

• Infineon EVAL_PMG1_B1_DRP