NXP FRDM-MCXA156
This article describes specifics for the NXP FRDM-MCXA156 evaluation board.
Preparing for J-Link
- Connect the J-Link to J24, JP8 hast to set in order to disable MCU-Link on the PCB and work with J-Link.
- Power the board via USB J21.
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the NXP FRDM-MCXA156.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.96a
- Embedded Studio: V7.20
- Hardware: NXP FRDM-MCXA156
- Link: File:NXP FRDM-MCXA156 MCXA156VL TestProject ES V720.zip