Difference between revisions of "AICH ECBMCU105H"
Arne.kulinna (talk | contribs) (Created page with "__TOC__ This article describes specifics for the AICH ECBMCU105H evaluation board. It can be used to test & verify 306xH device support. 450px...") |
|||
| Line 1: | Line 1: | ||
| + | [[Category:Evalboards]] |
||
__TOC__ |
__TOC__ |
||
Latest revision as of 14:21, 10 May 2024
This article describes specifics for the AICH ECBMCU105H evaluation board. It can be used to test & verify 306xH device support.
Minimum requirements
- J-Link software V7.92o or later
Preparing for J-Link
- Connect the J-Link to the SWD header (J9) using single wires
- Pin 1 - 3V3
- Pin 7 - SWDIO
- Pin 8 - SWDCK
- Pin 4 - GND
- Power the board via external power supply USB (J6)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
