AICH ECBMCU105H
This article describes specifics for the AICH ECBMCU105H evaluation board. It can be used to test & verify 306xH device support.
Minimum requirements
- J-Link software V7.92o or later
Preparing for J-Link
- Connect the J-Link to the SWD header (J9) using single wires
- Pin 1 - 3V3
- Pin 7 - SWDIO
- Pin 8 - SWDCK
- Pin 4 - GND
- Power the board via external power supply USB (J6)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows: