Analog Devices EV-ADuCM340ARDZ

From SEGGER Wiki
Revision as of 11:51, 10 February 2023 by Erik (talk | contribs) (Created page with "__TOC__ This article describes specifics for the Analog Devices EV-ADuCM340ARDZ evaluation board.<br> 450px == Preparing for J-Link...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

This article describes specifics for the Analog Devices EV-ADuCM340ARDZ evaluation board.
AnalogDevices EV-ADuCM430ARDZ.jpg

Preparing for J-Link

  • Connect the J-Link via P11 to the target board
  • Power the board via P34 (5V center positive)
  • Verify the Connection with e.g. J-Link Commander. The output should look as follows:

AnalogDevices EV-ADuCM430ARDZ JLinkCommander Connect.PNG

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Analog Devices EV-ADuCM430ARDZ.
It is a simple Hello World sample linked into the internal flash.

SETUP

Retrieved from "https://wiki.segger.com/index.php?title=Analog_Devices_EV-ADuCM340ARDZ&oldid=14123"