Analog Devices EV-ADuCM340ARDZ
This article describes specifics for the Analog Devices EV-ADuCM340ARDZ evaluation board.
Preparing for J-Link
- Connect the J-Link via P11 to the target board
- Power the board via P34 (5V center positive)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Analog Devices EV-ADuCM430ARDZ.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.86
- Embedded Studio: V6.34a
- Hardware: Analog Devices EV-ADuCM340ARDZ
- Link: File:AnalogDevices ADuCM340 TestProject ES 634a.zip