Analog Devices EV-ADuCM340ARDZ

This article describes specifics for the Analog Devices EV-ADuCM340ARDZ evaluation board.

Preparing for J-Link

• Connect the J-Link via P11 to the target board
• Power the board via P34 (5V center positive)
• Verify the Connection with e.g. J-Link Commander. The output should look as follows:

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Analog Devices EV-ADuCM430ARDZ.
It is a simple Hello World sample linked into the internal flash.

SETUP

• J-Link software: V7.86
• Embedded Studio: V6.34a
• Hardware: Analog Devices EV-ADuCM340ARDZ
• Link: File:AnalogDevices ADuCM340 TestProject ES 634a.zip