Difference between revisions of "ArteryTek AT-START-F421"
(One intermediate revision by one other user not shown) | |||
Line 1: | Line 1: | ||
+ | [[Category:Evalboards]] |
||
__TOC__ |
__TOC__ |
||
This article describes specifics for the ArteryTek AT-START-F421 evaluation board.<br> |
This article describes specifics for the ArteryTek AT-START-F421 evaluation board.<br> |
Latest revision as of 14:27, 10 May 2024
This article describes specifics for the ArteryTek AT-START-F421 evaluation board.
Preparing for J-Link
- Connect the J-Link to this pins:
J-Link Pin | Connector | Pin | Name |
---|---|---|---|
VTref | J1 | 24 | VDD |
GND | J1 | 23 | GND |
SWDIO | J1 | 10 | PA13 |
SWCLK | J1 | 13 | PA14 |
RESET | J2 | 7 | NRST |
- Power the board via CH4.
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the ArteryTek AT-START-F425.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.94h
- Embedded Studio: V7.20
- Hardware: ArteryTek AT-START-F421
- Link: File:Artery AT-START-F421 AT32F421C8T7 TestProject ES 7V20.zip