ArteryTek AT-START-F421
Revision as of 18:57, 22 January 2024 by Torben.scharping (talk | contribs) (→Preparing for J-Link)
This article describes specifics for the Artery AT-START-F421 evaluation board.
450px
Preparing for J-Link
- Connect the J-Link to this pins:
| J-Link Pin | Connector | Pin | Name |
|---|---|---|---|
| VTref | J1 | 24 | VDD |
| GND | J1 | 23 | GND |
| SWDIO | J1 | 10 | PA13 |
| SWCLK | J1 | 13 | PA14 |
| RESET | J2 | 7 | NRST |
- Power the board via USB (CN2 or CN3).
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Artery AT-START-F425.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.94g
- Embedded Studio: V7.20
- Hardware: Artery AT-START-F421
- Link: File:Artery AT-START-F425 AT32F425R8T7-7 TestProject ES 7V20.zip
