Difference between revisions of "DA14583 series"
(→Reset pin) |
|||
| Line 3: | Line 3: | ||
The Dialog Semiconductor DA14583 is a low power Bluetooth device, based on the Cortex-M0 core. |
The Dialog Semiconductor DA14583 is a low power Bluetooth device, based on the Cortex-M0 core. |
||
= Reset pin = |
= Reset pin = |
||
| − | The Dialog Semiconductor DA14583 series devices have a reset pin called RST. In contrast to almost all other devices supported by J-Link, the RST pin on this series is an active HIGH pin. Usually reset pin is active LOW. By hardware design, the reset pin on J-Link is also active LOW. In order to use J-Link with the DA14583 series devices, please make sure that RST of the target device is '''not''' connected to the reset pin controlled by J-Link or make sure that an inverter is between. |
+ | The Dialog Semiconductor DA14583 series devices have a reset pin called RST. In contrast to almost all other devices supported by J-Link, the RST pin on this series is an active HIGH pin. Usually reset pin is active LOW. By hardware design, the reset pin on J-Link is also active LOW. In order to use J-Link with the DA14583 series devices, please make sure that RST of the target device is '''not''' connected to the reset pin controlled by J-Link or make sure that an inverter is between. Not doing so may result in J-Link being unable to establish a connection to the core. |
As J-Link usually uses the AIRCR register of the Cortex-M cores to issue a reset via software and the DA14583 is a Cortex-M0 based device, the RST pin of this device is usually not needed by J-Link to do proper debugging. |
As J-Link usually uses the AIRCR register of the Cortex-M cores to issue a reset via software and the DA14583 is a Cortex-M0 based device, the RST pin of this device is usually not needed by J-Link to do proper debugging. |
||
Latest revision as of 15:22, 15 August 2018
Contents
The Dialog Semiconductor DA14583 is a low power Bluetooth device, based on the Cortex-M0 core.
Reset pin
The Dialog Semiconductor DA14583 series devices have a reset pin called RST. In contrast to almost all other devices supported by J-Link, the RST pin on this series is an active HIGH pin. Usually reset pin is active LOW. By hardware design, the reset pin on J-Link is also active LOW. In order to use J-Link with the DA14583 series devices, please make sure that RST of the target device is not connected to the reset pin controlled by J-Link or make sure that an inverter is between. Not doing so may result in J-Link being unable to establish a connection to the core.
As J-Link usually uses the AIRCR register of the Cortex-M cores to issue a reset via software and the DA14583 is a Cortex-M0 based device, the RST pin of this device is usually not needed by J-Link to do proper debugging.
