Difference between revisions of "EFM Starter Kits"
(8 intermediate revisions by the same user not shown) | |||
Line 7: | Line 7: | ||
=== Solution === |
=== Solution === |
||
In the following it is described how to configure a J-Link-OB on these kits to allow an external probe to connect to the target device: |
In the following it is described how to configure a J-Link-OB on these kits to allow an external probe to connect to the target device: |
||
+ | |||
− | * Make sure that Simplicity Studio from Silicon Labs is installed |
||
+ | <ul> |
||
− | * Connect the J-Link-OB on the kit to the host PC via USB |
||
− | + | <li>Make sure that Simplicity Studio from Silicon Labs is installed</li> |
|
+ | <li>Connect the J-Link-OB on the kit to the host PC via USB</li> |
||
− | * Make sure that the Kit Manager is installed PICTURE!!!!!!!!!!!!! |
||
− | + | <li>Start Simplicity Studio</li> |
|
+ | <li>Make sure that the Kit Manager is installed<br /> |
||
− | * Select Debug Mode == In |
||
+ | [[File:SimplicityStudio_InstallKitManager_1.png]]<br /> |
||
+ | [[File:SimplicityStudio_InstallKitManager_2.png]]<br /><br /></li> |
||
+ | <li>Start the Kit Manager<br /> |
||
+ | [[File:SimplicityStudio_ReconfigOB_1.png]]<br /><br /></li> |
||
+ | <li>Select Debug Mode == In<br /> |
||
+ | [[File:SimplicityStudio_ReconfigOB_2.png]]</li> |
||
+ | </ul> |
Latest revision as of 18:35, 19 May 2016
How to connect an external J-Link
Problem description
By default, the Silicon Labs EFM starter kits are configured to only be debugged via the J-Link-OB on the kits. In case an external J-Link shall be used for debugging the target device on the kit, the OB on the kit needs to be reconfigured via utilities from Silicon Labs, to allow an external probe to connect.
Solution
In the following it is described how to configure a J-Link-OB on these kits to allow an external probe to connect to the target device: