Geehy APM32F103ZET6
This article describes specifics for the APEXMIC APM32F103ZET6 evaluation board. It can be used to test & verify APM32F103xx device support.
Minimum requirements
- J-Link software V6.84 or later
Preparing for J-Link
- Connect the J-Link to the JTAG header (J5)
- Power the board via external power supply USB (J2)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the APEXMIC APM32F103ZET6. It is a simple Hello World sample linked into the internal flash. SETUP
- J-Link software: V6.84
- Embedded Studio: V5.10
- Hardware: APEXMIC APM32F103ZET6
- Link: File:Geehy APM32F103ZE TestProject ES V510.zip