Difference between revisions of "GigaDevice GD32A503-EVAL"
(Created page with "__TOC__ This article describes specifics for the GigaDevice GD32A503-EVAL evaluation board. 450px == Minimum requirements == * J-Li...") |
|||
(15 intermediate revisions by the same user not shown) | |||
Line 3: | Line 3: | ||
This article describes specifics for the GigaDevice GD32A503-EVAL evaluation board. |
This article describes specifics for the GigaDevice GD32A503-EVAL evaluation board. |
||
− | [[File: |
+ | [[File:GD_GD32A503V-EVAL_Board.jpg|500px]] |
== Minimum requirements == |
== Minimum requirements == |
||
− | * J-Link software |
+ | * J-Link software V7.82b or later |
== Preparing for J-Link == |
== Preparing for J-Link == |
||
− | *Connect the J-Link to the |
+ | *Connect the J-Link to the JTAG header (JP2) |
− | *Power the board via |
+ | *Power the board via USB (GD-LINK CN100) |
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
||
− | [[File: |
+ | [[File:GD_GD32A503_EVAL_GD32A503VD Connect.png|400px]] |
== Example Project== |
== Example Project== |
||
− | The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the |
+ | The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the GigaDevice GD32A503-EVAL. <br> |
It is a simple Hello World sample linked into the internal flash.<br> |
It is a simple Hello World sample linked into the internal flash.<br> |
||
====SETUP==== |
====SETUP==== |
||
− | *J-Link software: |
+ | *J-Link software: V7.82b |
*Embedded Studio: V6.34 |
*Embedded Studio: V6.34 |
||
− | *Hardware: |
+ | *Hardware: GigaDevice GD32A503-EVAL |
− | *Link: [[File: |
+ | *Link: [[File:GigaDevice_GD32A503V-EVAL_GD32A503VD.zip]] |
Latest revision as of 12:11, 11 November 2022
This article describes specifics for the GigaDevice GD32A503-EVAL evaluation board.
Minimum requirements
- J-Link software V7.82b or later
Preparing for J-Link
- Connect the J-Link to the JTAG header (JP2)
- Power the board via USB (GD-LINK CN100)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the GigaDevice GD32A503-EVAL.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.82b
- Embedded Studio: V6.34
- Hardware: GigaDevice GD32A503-EVAL
- Link: File:GigaDevice GD32A503V-EVAL GD32A503VD.zip