Difference between revisions of "GigaDevice GD32F310C-EVAL"
(Created page with "__TOC__ This article describes specifics for the GigaDevice GD32F310C-EVAL evaluation board.<br> 450px == Preparing f...") |
(→Example Project) |
||
Line 23: | Line 23: | ||
== Example Project== |
== Example Project== |
||
− | The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the GigaDevice |
+ | The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the GigaDevice GD32F310C-EVAL.<br>It is a simple Hello World sample linked into the internal flash.<br> |
====SETUP==== |
====SETUP==== |
||
*Embedded Studio: V7.12a |
*Embedded Studio: V7.12a |
||
*Hardware: GigaDevice GD32F310C-EVAL |
*Hardware: GigaDevice GD32F310C-EVAL |
||
− | *Link: [[File: |
+ | *Link: [[File:GigaDevice_GD32F310C8_TestProject_ES_7V12a.zip]] |
Latest revision as of 18:29, 27 February 2024
This article describes specifics for the GigaDevice GD32F310C-EVAL evaluation board.
Preparing for J-Link
- Connect the J-Link to this pins:
J-Link Pin | Connector | Pin | Name |
---|---|---|---|
VTref | JP1 | 4 | +3V3 |
GND | JP1 | 3 | GND |
TMS/SWDIO | JP1 | 2 | IO |
TCK/SWCLK | JP1 | 1 | CK |
- Power the board via CN100.
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the GigaDevice GD32F310C-EVAL.
It is a simple Hello World sample linked into the internal flash.
SETUP
- Embedded Studio: V7.12a
- Hardware: GigaDevice GD32F310C-EVAL
- Link: File:GigaDevice GD32F310C8 TestProject ES 7V12a.zip