Difference between revisions of "GigaDevice GD32L233R-EVAL"
(Created page with "__TOC__ This article describes specifics for the GigaDevice GD32L233R-EVAL evaluation board. 450px == Minimum requirements == * J-Li...") |
|||
(One intermediate revision by one other user not shown) | |||
Line 1: | Line 1: | ||
+ | [[Category:Evalboards]] |
||
__TOC__ |
__TOC__ |
||
Line 9: | Line 10: | ||
== Preparing for J-Link == |
== Preparing for J-Link == |
||
− | *Connect the J-Link to the pins as seen in the image |
+ | *Connect the J-Link to the pins as seen in the image below: |
[[File:GigaDevice_GD32L233R-EVAL_connected.jpg|450px]] |
[[File:GigaDevice_GD32L233R-EVAL_connected.jpg|450px]] |
Latest revision as of 15:26, 8 May 2024
This article describes specifics for the GigaDevice GD32L233R-EVAL evaluation board.
Minimum requirements
- J-Link software V7.67c or later
Preparing for J-Link
- Connect the J-Link to the pins as seen in the image below:
- Power the board via usb power supply
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the GigaDevice GD32L233R-EVAL. It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.67c
- Embedded Studio: V6.22a
- Hardware: GigaDevice GD32L233R-EVAL
- Link: File:GigaDevice GD32L233R-EVAL TestProject ES V622a.zip