Difference between revisions of "GigaDevice GD32VW553K-START"
(→Preparing for J-Link) |
(→Preparing for J-Link) |
||
Line 5: | Line 5: | ||
== Preparing for J-Link == |
== Preparing for J-Link == |
||
− | *Connect the J-Link to: |
+ | *Connect the J-Link to: VTref@J9.1 GND@J9.4 TCK@Jx. TDI@Jx. TDO@Jx. RESET@Jx. . |
*Power the board via J8. |
*Power the board via J8. |
||
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
Latest revision as of 11:13, 15 January 2024
This article describes specifics for the GigaDevice GD32VW553K-START evaluation board.
Preparing for J-Link
- Connect the J-Link to: VTref@J9.1 GND@J9.4 TCK@Jx. TDI@Jx. TDO@Jx. RESET@Jx. .
- Power the board via J8.
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the GigaDevice GD32VW553K-START.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.92l
- Embedded Studio: V6.34
- Hardware: GigaDevice GD32VW553K-START
- Link: File:GigaDevice GD32VW553H-EVAL GD32VW553H TestProject ES V634.zip