HDSC EV-HC32F460

From SEGGER Wiki
Revision as of 18:17, 22 December 2021 by Matthias (talk | contribs) (Created page with "__TOC__ This article describes specifics for the HDSC EV-HC32F460-LQFP100-050-V1.3 evaluation board. 450px == Minimum requirements == * J-Lin...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

This article describes specifics for the HDSC EV-HC32F460-LQFP100-050-V1.3 evaluation board.

HDSC EV-HC32F460.jpg

Minimum requirements

  • J-Link software V7.60b or later

Preparing for J-Link

  • Connect the J-Link debug connector.
  • Power the board via usb power supply
  • The board should look like this:

HDSC EV-HC32F460 connected.jpg

  • Verify the Connection with e.g. J-Link Commander. The output should look as follows:

HDSC EV-HC32F460 Connect.PNG

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the HDSC EV-HC32F460-LQFP100-050-V1.3. It is a simple Hello World sample linked into the internal flash.

SETUP

Retrieved from "https://wiki.segger.com/index.php?title=HDSC_EV-HC32F460&oldid=11247"