Difference between revisions of "HPMicro HPM6750EVKMINI"
(Created page with "__TOC__ This article describes specifics for the '''HPMicro HPM6750EVKMINI''' evaluation board. 450px == Minimum requirements == * J-Lin...") |
|||
Line 22: | Line 22: | ||
[[File:HPM6750EVKMINI_Wired.jpg | 500px | HPM6750EVKMINI wired]] |
[[File:HPM6750EVKMINI_Wired.jpg | 500px | HPM6750EVKMINI wired]] |
||
− | * Power the board via the USB port ( |
+ | * Power the board via the USB port (J3). |
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
||
Revision as of 15:18, 8 March 2022
This article describes specifics for the HPMicro HPM6750EVKMINI evaluation board.
Minimum requirements
- J-Link software V7.63c or later
Preparing for J-Link
To use HPM6750EVKMINI with an external J-Link some soldering is neccessary.
- Disconnect TCK and TRST to FT2232 by removing R45 and R49
- Connect TDO (T7), TDI (T8), TCK (T9), TMS (T10), and TRST (T11) to external debug probe.
- Vref and GND can be connected from R44 and R51 respectively.
After that, connect the board with the soldered on wires to your J-Link (see table below)
For information about the J-Link pinout please refer to the following page: J-Link JTAG pinout.
The result should be looking like this:
- Power the board via the USB port (J3).
- Verify the Connection with e.g. J-Link Commander. The output should look as follows: