Difference between revisions of "HSXP HK32F030M"
(Created page with "__TOC__ This article describes specifics for the HSXP_HK32F030M evaluation board. It can be used to test & verify HK32F03xx series device support. File:HSXP_HK32F030M.jpg|...") |
(No difference)
|
Revision as of 10:25, 10 January 2022
This article describes specifics for the HSXP_HK32F030M evaluation board. It can be used to test & verify HK32F03xx series device support.
Minimum requirements
- J-Link software V7.60c or later
Preparing for J-Link
- Connect the J-Link to the SWD header (CN1) on the right side
- Power the board via the USB connector
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the NXP JN5189-DK006. It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.60c
- Embedded Studio: V5.50d
- Hardware: HSXP HK32F030M /HK32F0301M
- Link: File:HSXP HK32F030xx TestProject ES V550d.zip