From SEGGER Wiki
Revision as of 10:26, 10 January 2022 by Sebastian (talk | contribs)
Jump to: navigation, search

This article describes specifics for the HSXP_HK32F030M/0301M evaluation board. It can be used to test & verify HK32F03xx series device support.

HSXP HK32F030M.jpg

Minimum requirements

  • J-Link software V7.60c or later

Preparing for J-Link

  • Connect the J-Link to the SWD header (CN1) on the right side
  • Power the board via the USB connector

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the NXP JN5189-DK006. It is a simple Hello World sample linked into the internal flash.