Difference between revisions of "IndieSemi Realplum-EVK"
(→Example Project) |
(→Preparing for J-Link) |
||
Line 15: | Line 15: | ||
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
||
− | [[File: |
+ | [[File:IndieSemi_Realplum_Connect.PNG|400px]] |
== Example Project== |
== Example Project== |
Revision as of 15:00, 19 August 2020
This article describes specifics for the IndieSemi Realplum EVK.
Minimum requirements
- J-Link software V6.84 or later
Preparing for J-Link
- Make sure that you install the correct "Upgrade Board"
- Connect the J-Link to the SWD header (P1)
- Power the board via external power supply / power jack (J4)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the IndieSemi Realplum. It is a simple Hello World sample linked into the internal flash. SETUP
- J-Link software: >= V6.83d
- Embedded Studio: >= V4.52b
- Hardware: IndieSemi Realplum EVK
- Link: File:IndieSemi Realplum TestProject ES V452b.zip