Difference between revisions of "Infineon DAVE 4"
m (Leon moved page DAVE 4 (Infineon) to Infineon DAVE 4: Fixed name of IDE. Brackets should not be used in wiki titles) |
(→Getting started) |
||
| Line 18: | Line 18: | ||
=== Using an Existing Project With J-Link === |
=== Using an Existing Project With J-Link === |
||
| − | * Build the DAVE project that should be used with J-Link: |
+ | * Build the DAVE project that should be used with J-Link: |
| + | |||
| − | * Navigate to '''Debug Configurations''' by clicking the arrow next to the bug symbol: <br> [[File:DAVE4_FindDebugConfigs.png | border]] |
||
| + | [[File:DAVE4_BuildProject.png | border]] |
||
| − | * Double-click '''GDB SEGGER J-Link Debugging'''. This will create a new debug configuration: <br> [[File:DAVE4_DebugConfs.png | border]] |
||
| + | |||
| − | * Select the newly created debug configuration and select the '''Debugger''' tab: <br> [[File:DAVE4_DebuggerOpt.png]] |
||
| + | * Navigate to '''Debug Configurations''' by clicking the arrow next to the bug symbol: |
||
| + | |||
| + | [[File:DAVE4_FindDebugConfigs.png | border]] |
||
| + | |||
| + | * Double-click '''GDB SEGGER J-Link Debugging'''. This will create a new debug configuration: |
||
| + | |||
| + | [[File:DAVE4_DebugConfs.png | border]] |
||
| + | |||
| + | * Select the newly created debug configuration and select the '''Debugger''' tab: |
||
| + | |||
| + | [[File:DAVE4_DebuggerOpt.png|800px]] |
||
| + | |||
* Make sure that the correct '''Device name''' is set. |
* Make sure that the correct '''Device name''' is set. |
||
* Make sure that the correct '''Endianness''' is set. Most Infineon devices use '''Little Endian'''. |
* Make sure that the correct '''Endianness''' is set. Most Infineon devices use '''Little Endian'''. |
||
Latest revision as of 10:38, 9 October 2020
Infineon DAVE 4 is a free IDE, based on Eclipse, for Infineon XMC devices. Infineon DAVE comes with built-in J-Link GDB Server support.
Note: J-Link GDB Server is part of the J-Link Software and Documentation Pack and can be used free of charge.
Getting started
Installing
When installing Infineon DAVE 4 IDE, make sure to check SEGGER J-Link ... under Custom Setup.
Other than that, please refer to the DAVE-4[...].pdf provided by Infineon within the DAVE installation package to installing the IDE.
Using an Existing Project With J-Link
- Build the DAVE project that should be used with J-Link:
- Navigate to Debug Configurations by clicking the arrow next to the bug symbol:
- Double-click GDB SEGGER J-Link Debugging. This will create a new debug configuration:
- Select the newly created debug configuration and select the Debugger tab:
- Make sure that the correct Device name is set.
- Make sure that the correct Endianness is set. Most Infineon devices use Little Endian.
- Make sure that the correct Interface is set. Most Infineon devices use SWD for the target interface.
- If necessary, click Apply.
- Click Debug to start debugging the target application.
