Difference between revisions of "J-Link Configurator"
(→Options) |
(→Don't show again settings) |
||
(3 intermediate revisions by the same user not shown) | |||
Line 40: | Line 40: | ||
== Options == |
== Options == |
||
===System wide settings=== |
===System wide settings=== |
||
− | ==== |
+ | ====Do not show again settings==== |
How to reset "Don't show again" settings: |
How to reset "Don't show again" settings: |
||
#Click ''Options'' --> ''System wide settings'' from the main menu |
#Click ''Options'' --> ''System wide settings'' from the main menu |
||
#Check ''Reset "Don't show again"'' |
#Check ''Reset "Don't show again"'' |
||
#Confirm the selection using ''OK'' |
#Confirm the selection using ''OK'' |
||
+ | [[File:JLinkConfigurator_DontShowAgain.png]] |
Revision as of 14:06, 22 September 2023
The J-Link Configurator is a cross platform (Windows, Linux and MacOS) GUI application to configure certain features of a J-Link, J-Trace or Flasher. It is part of the J-Link Software and Documentation Pack available on the SEGGER Homepage.
Features
In most cases, no configuration is required, especially when using J-Link via USB, as it is designed to work out-of-the-box. If required, the following settings can be changed via the J-Link Configurator:
- Re-configuring older J-Links to be identified by their real serial number when enumerating on the host PC (required when connecting > 3 older J-Links to one host pc)
- Configuration of the IP settings (use DHCP, IP address, subnet mask, ...) of a J-Link supporting the Ethernet interface
- Enabling/Disabling VCOM functionality, if supported.
- Updating the firmware of multiple emulators connected via USB or TCP/IP easily.
- Adding a nickname to an emulator.
Configure J-Links using the J-Link Configurator
A J-Link can be configured easily by selecting the appropriate J-Link from the emulator list and using right click -> Configure or double-clicking it.
Configuring DHCP and IP
This feature is only available for emulators (e.g J-Link) with an Ethernet interface. To manually configure the IP settings of the connected emulator, under IP Configuration click on Manual.
Enabling/Disabling VCOM
To configure VCOM, click on "Enable VCOM" (requires emulator reset)
Adding a Nickname
A nickname can be assigned to a connected emulator to make it easier to recognize. This nickname will also be shown in the device selection dialog.
Configuring Bootmode
To configure Boot mode for J-Link, selcet "J-Link" (requires emulator reset)
To configure Boot mode for CMSIS, selcet "CMSIS" (requires emulator reset)
Options
System wide settings
Do not show again settings
How to reset "Don't show again" settings:
- Click Options --> System wide settings from the main menu
- Check Reset "Don't show again"
- Confirm the selection using OK