Difference between revisions of "Mindmotion-MB-032"
(One intermediate revision by the same user not shown) | |||
Line 6: | Line 6: | ||
== Minimum requirements == |
== Minimum requirements == |
||
− | * J-Link software V7. |
+ | * J-Link software V7.82e or later |
== Preparing for J-Link == |
== Preparing for J-Link == |
||
Line 19: | Line 19: | ||
It is a simple Hello World sample linked into the internal flash.<br> |
It is a simple Hello World sample linked into the internal flash.<br> |
||
====SETUP==== |
====SETUP==== |
||
− | *J-Link software: V7. |
+ | *J-Link software: V7.82e |
*Embedded Studio: V6.34 |
*Embedded Studio: V6.34 |
||
*Hardware: Mindmotion MB-032 |
*Hardware: Mindmotion MB-032 |
||
− | *Link: [[File: |
+ | *Link: [[File:MM_MM32-032_MM32F0010A1T_TestProject_ES_V634.zip]] |
Latest revision as of 16:07, 9 December 2022
This article describes specifics for the Mindmotion MB-032 evaluation board.
Minimum requirements
- J-Link software V7.82e or later
Preparing for J-Link
- Connect the J-Link : VTref= CN6-9 / GND=CN6-7 / SWDIO=CN9-8(18 on PCB) / SWDCLK=CN6-4
- Power the board via USB (CN3)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Mindmotion MB-032 MM32F0010A1T.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.82e
- Embedded Studio: V6.34
- Hardware: Mindmotion MB-032
- Link: File:MM MM32-032 MM32F0010A1T TestProject ES V634.zip