Difference between revisions of "Mindmotion-MB-032"
| Line 9: | Line 9: | ||
== Preparing for J-Link == |
== Preparing for J-Link == |
||
| − | *Connect the J-Link |
+ | *Connect the J-Link ######################################### |
*Power the board via USB (CN3) |
*Power the board via USB (CN3) |
||
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
||
| Line 22: | Line 22: | ||
*Embedded Studio: V6.34 |
*Embedded Studio: V6.34 |
||
*Hardware: Mindmotion MB-036 |
*Hardware: Mindmotion MB-036 |
||
| − | *Link: [[File: |
+ | *Link: [[File:MM_xxx_TestProject_ES_V634.zip]] |
Revision as of 12:37, 28 November 2022
This article describes specifics for the Mindmotion MB-032 evaluation board.
Minimum requirements
- J-Link software V7.82d or later
Preparing for J-Link
- Connect the J-Link #########################################
- Power the board via USB (CN3)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Mindmotion MB-036 MM32F3270##########################################.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.82d
- Embedded Studio: V6.34
- Hardware: Mindmotion MB-036
- Link: File:MM xxx TestProject ES V634.zip
