Difference between revisions of "Mindmotion-MB-036"
(One intermediate revision by one other user not shown) | |||
Line 1: | Line 1: | ||
+ | [[Category:Evalboards]] |
||
__TOC__ |
__TOC__ |
||
Line 22: | Line 23: | ||
*Embedded Studio: V6.34 |
*Embedded Studio: V6.34 |
||
*Hardware: Mindmotion MB-036 |
*Hardware: Mindmotion MB-036 |
||
− | *Link: [[File: |
+ | *Link: [[File:MM_MM32-036_MM32F3277G7P_TestProject_ES_V634.zip]] |
Latest revision as of 15:35, 8 May 2024
This article describes specifics for the Mindmotion MB-036 evaluation board.
Minimum requirements
- J-Link software V7.82e or later
Preparing for J-Link
- Connect the J-Link: VTref= CN9-32(64 on PCB) / GND=CN9-31(63 on PCB) / SWDIO=CN9-14(46 on PCB) / SWDCLK=CN9-17(49on PCB)
- Power the board via USB (CN2)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Mindmotion MB-036 MM32F3277G7P.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.82e
- Embedded Studio: V6.34
- Hardware: Mindmotion MB-036
- Link: File:MM MM32-036 MM32F3277G7P TestProject ES V634.zip