Difference between revisions of "Mindmotion-NANO-F0270"
Line 10: | Line 10: | ||
== Preparing for J-Link == |
== Preparing for J-Link == |
||
*Connect the J-Link to J4 |
*Connect the J-Link to J4 |
||
− | *Power the board via USB ( |
+ | *Power the board via USB (UART or USB port) |
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
||
Revision as of 17:28, 9 December 2022
This article describes specifics for the Mindmotion NANO-F0270 evaluation board.
Minimum requirements
- J-Link software V7.82d or later
Preparing for J-Link
- Connect the J-Link to J4
- Power the board via USB (UART or USB port)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Mindmotion NANO-F0270 ##########################################.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.82d
- Embedded Studio: V6.34
- Hardware: Mindmotion NANO-F0270
- Link: File:MM xxx TestProject ES V634.zip