Difference between revisions of "NUCLEO-F070RB"
(Created page with "__TOC__ == How to use external debug probe with Nucleo board == Some ST Nucleo boards can be connected to an external debug probe like J-Link. To do this check the schematics...") |
(→How to use external debug probe with Nucleo board) |
||
Line 1: | Line 1: | ||
__TOC__ |
__TOC__ |
||
− | == How to use external debug probe with Nucleo board == |
+ | == How to use an external debug probe with Nucleo board == |
Some ST Nucleo boards can be connected to an external debug probe like J-Link. To do this check the schematics to see if the debug signals are routed to the Extension Connectors. These can then be connected with e.g. jumper wires to the J-Link debug interface. |
Some ST Nucleo boards can be connected to an external debug probe like J-Link. To do this check the schematics to see if the debug signals are routed to the Extension Connectors. These can then be connected with e.g. jumper wires to the J-Link debug interface. |
||
Latest revision as of 15:16, 7 February 2019
How to use an external debug probe with Nucleo board
Some ST Nucleo boards can be connected to an external debug probe like J-Link. To do this check the schematics to see if the debug signals are routed to the Extension Connectors. These can then be connected with e.g. jumper wires to the J-Link debug interface.
In case of the NUCLEO-F070RB the wiring is as follows:
Nucleo Pin (Connector/Pin) | J-Link debug signal (Pin) |
---|---|
GND (CN7_8) | GND (4) |
+3V3 (CN7_16) | VTref (1) |
PA13 (CN7_13) | SWDIO (7) |
PA14 (CN7_15) | SWCLK (9) |
RESET (CN7_14) | RESET (15) |
To make sure the on board ST-Link does not interfere with your probe additionally disconnect the two jumpers on CN2.