Difference between revisions of "NXP FRDM-MCXA156"
(Created page with "__TOC__ This article describes specifics for the NXP FRDM-MCXN236 evaluation board.<br> 450px == Preparing for J-Link == *Con...") |
(→SETUP) |
||
(4 intermediate revisions by the same user not shown) | |||
Line 1: | Line 1: | ||
__TOC__ |
__TOC__ |
||
− | This article describes specifics for the NXP FRDM- |
+ | This article describes specifics for the NXP FRDM-MCXA156 evaluation board.<br> |
− | [[File: |
+ | [[File:NXP_FRDM-MCXA156_MCXA156VL_board.jpg|450px]] |
== Preparing for J-Link == |
== Preparing for J-Link == |
||
− | *Connect the J-Link to |
+ | *Connect the J-Link to J24, JP8 hast to set in order to disable MCU-Link on the PCB and work with J-Link. |
− | *Power the board via USB |
+ | *Power the board via USB J21. |
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
||
− | [[File: |
+ | [[File:NXP_FRDM-MCXA156_MCXA156VL_connect.png|400px]] |
== Example Project== |
== Example Project== |
||
Line 14: | Line 14: | ||
It is a simple Hello World sample linked into the internal flash.<br> |
It is a simple Hello World sample linked into the internal flash.<br> |
||
====SETUP==== |
====SETUP==== |
||
− | *J-Link software: V7. |
+ | *J-Link software: V7.96a |
*Embedded Studio: V7.20 |
*Embedded Studio: V7.20 |
||
*Hardware: NXP FRDM-MCXA156 |
*Hardware: NXP FRDM-MCXA156 |
||
− | *Link: [[File: |
+ | *Link: [[File:NXP_FRDM-MCXA156_MCXA156VL_TestProject_ES_V720.zip]] |
Latest revision as of 11:08, 13 March 2024
This article describes specifics for the NXP FRDM-MCXA156 evaluation board.
Preparing for J-Link
- Connect the J-Link to J24, JP8 hast to set in order to disable MCU-Link on the PCB and work with J-Link.
- Power the board via USB J21.
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the NXP FRDM-MCXA156.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.96a
- Embedded Studio: V7.20
- Hardware: NXP FRDM-MCXA156
- Link: File:NXP FRDM-MCXA156 MCXA156VL TestProject ES V720.zip