Difference between revisions of "NXP FRDM-MCXA156"
(→Preparing for J-Link) |
(→SETUP) |
||
(2 intermediate revisions by the same user not shown) | |||
Line 14: | Line 14: | ||
It is a simple Hello World sample linked into the internal flash.<br> |
It is a simple Hello World sample linked into the internal flash.<br> |
||
====SETUP==== |
====SETUP==== |
||
− | *J-Link software: V7. |
+ | *J-Link software: V7.96a |
*Embedded Studio: V7.20 |
*Embedded Studio: V7.20 |
||
*Hardware: NXP FRDM-MCXA156 |
*Hardware: NXP FRDM-MCXA156 |
||
− | *Link: [[File: |
+ | *Link: [[File:NXP_FRDM-MCXA156_MCXA156VL_TestProject_ES_V720.zip]] |
Latest revision as of 11:08, 13 March 2024
This article describes specifics for the NXP FRDM-MCXA156 evaluation board.
Preparing for J-Link
- Connect the J-Link to J24, JP8 hast to set in order to disable MCU-Link on the PCB and work with J-Link.
- Power the board via USB J21.
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the NXP FRDM-MCXA156.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.96a
- Embedded Studio: V7.20
- Hardware: NXP FRDM-MCXA156
- Link: File:NXP FRDM-MCXA156 MCXA156VL TestProject ES V720.zip