Difference between revisions of "NXP JN5189-DK006"
(→Debugging in SEGGER Embedded Studio) |
(→Example Project) |
||
(3 intermediate revisions by the same user not shown) | |||
Line 1: | Line 1: | ||
__TOC__ |
__TOC__ |
||
− | This article describes specifics for the NXP JN5189-DK006 evaluation board. |
+ | This article describes specifics for the NXP JN5189-DK006 evaluation board. The board supports different Upgrade boards. It can be used to test & verify QN9090 and JN5189 support. |
− | [[File: |
+ | [[File:NXP_JN5189-DK006.jpg|450px]] |
== Minimum requirements == |
== Minimum requirements == |
||
Line 17: | Line 17: | ||
== Example Project== |
== Example Project== |
||
− | The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the NXP JN5189-DK006. It is a simple Hello World sample linked into the internal flash. |
+ | The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the NXP JN5189-DK006. It is a simple Hello World sample linked into the internal flash.<br> |
− | + | ====SETUP==== |
|
− | *J-Link software: V6. |
+ | *J-Link software: V6.74 |
*Embedded Studio: V4.52b |
*Embedded Studio: V4.52b |
||
*Hardware: NXP JN5189-DK006 (QN9090 upgrade board) |
*Hardware: NXP JN5189-DK006 (QN9090 upgrade board) |
Latest revision as of 11:32, 31 May 2021
This article describes specifics for the NXP JN5189-DK006 evaluation board. The board supports different Upgrade boards. It can be used to test & verify QN9090 and JN5189 support.
Minimum requirements
- J-Link software V6.74 or later
Preparing for J-Link
- Make sure that you install the correct "Upgrade Board"
- Connect the J-Link to the SWD header (P1)
- Power the board via external power supply / power jack (J4)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the NXP JN5189-DK006. It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V6.74
- Embedded Studio: V4.52b
- Hardware: NXP JN5189-DK006 (QN9090 upgrade board)
- Link: File:NXP QN9090 TestProject ES V452b.zip