NXP LPCXpresso55S36

This article describes specifics for the NXP LPCXpresso55S36 evaluation board.

Minimum requirements

• J-Link software V7.54 or later

Preparing for J-Link

The LPC55S36 EVK comes with a standard 20-Pin debug connector.

• Connect the J-Link to the 20-pin SWD debug connector
• Power the board using the mini USB connector

The result should be looking like this:

Example Application

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the LPCXpresso55S36. It is a simple Hello World sample linked into the internal flash.

SETUP:

• J-Link software: V7.54
• Embedded Studio: V5.50
• Hardware: NXP LPCXpresso55S36
• Link: File:NXP LPC55S36 TestProject ES V550.zip