Difference between revisions of "NXP MCX-A14X-EVK"
(Created page with "__TOC__ This article describes specifics for the NXP MCX-A14X-EVK evaluation board.<br> 450px == Preparing for J-Link == *Con...") |
(→SETUP) |
||
Line 14: | Line 14: | ||
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the NXP MCX-A14X-EVK.<br>It is a simple Hello World sample linked into the internal flash.<br> |
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the NXP MCX-A14X-EVK.<br>It is a simple Hello World sample linked into the internal flash.<br> |
||
====SETUP==== |
====SETUP==== |
||
− | *J-Link software: V7. |
+ | *J-Link software: V7.94D |
*Embedded Studio: V7.20b |
*Embedded Studio: V7.20b |
||
*Hardware: NXP MCX-A14X-EVK |
*Hardware: NXP MCX-A14X-EVK |
Latest revision as of 13:02, 10 January 2024
This article describes specifics for the NXP MCX-A14X-EVK evaluation board.
Preparing for J-Link
- Connect the J-Link to J18.
- Power the board via J8.
- Close Jumper JP20 (disable ST-Link on SWD).
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the NXP MCX-A14X-EVK.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.94D
- Embedded Studio: V7.20b
- Hardware: NXP MCX-A14X-EVK
- Link: File:NXPX-MCX-A14X-EVK MCXA143VLH TestProject ES 7V20.zip