Difference between revisions of "NXP MIMXRT106A-ALEXA2"
(Created page with "__TOC__ This article describes specifics for the NXP MIMXRT106A-ALEXA2 IoT evaluation board. TBD 450px == Minimum requirements == * J-Link sof...") |
(No difference)
|
Revision as of 14:56, 4 August 2020
This article describes specifics for the NXP MIMXRT106A-ALEXA2 IoT evaluation board.
TBD
Minimum requirements
- J-Link software V6.83c or later
Preparing for J-Link
- Connect the J-Link to the SWD header (J6)
- Power the board via USB C cable (CON1)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
TBD
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the NXP JN5189-DK006. It is a simple Hello World sample linked into the internal flash. SETUP
- J-Link software: V6.74
- Embedded Studio: V4.52b
- Hardware: NXP JN5189-DK006 (QN9090 upgrade board)
- Link: File:NXP QN9090 TestProject ES V452b.zip
